Hub PowerShell command reference
The installed TPHubPS module is the authority for available commands and parameters. Run Get-Command -Module TPHubPS to list its commands and Get-Help followed by a command name for details.
Connect to a Hub with PowerShell before running device commands.
|
Command or command pair |
Task |
|---|---|
|
Read, add or change printers. |
|
List printers connected to USB interfaces. |
|
Remove one printer or all printers. |
|
Read or set the default/current printer. |
|
Read or configure local discovery and automatic addition. |
|
Search the local subnet for printers. |
|
Work with discovered printers and discovery settings. |
|
Hide discovered printers or remove their hidden status. |
|
Read or configure global printer SNMP settings. |
|
Work with printer SNMP settings and status. Check module help for parameters. |
|
Read or change hostname, comments and location. |
|
Read or change IPv4 configuration. |
|
Read or configure Ethernet EAP network authentication. |
|
Work with SNMP settings for monitoring the Hub. Check module help for parameters. |
|
Read or enable ezeep cloud management, required for claiming. |
|
Connect printers to ezeep, inspect the connection or disconnect it. |
|
Read or set Pull Printing properties. |
|
Test the connection to the Pull Printing server. |
|
Read or manually assign card readers to USB interfaces. Automatic port recognition is available through the console. |
|
Read the last scanned card ID and the event’s date and time. |
|
Read or configure ezeep Pull Printing. |
|
Upload a certificate and unlock a password-protected certificate. |
|
Inspect or remove a certificate awaiting confirmation after upload. |
|
List uploaded certificates or remove a certificate not assigned to a function. |
|
Read or assign certificate functions. |
|
Find Hubs on the local subnet. |
|
Change a Hub’s address until its next reboot. |
|
Read or set the target Hub URL. |
|
Read or set the proxy used to access the target Hub. |
|
Read or configure the module’s certificate acceptance behavior. |
|
Read or change the system language. |
|
Change the Hub administrator password. |
|
Read or change whether the Hub disappears from Finder after five minutes. |
|
Sign in to or out of the Hub. |
|
Restart the Hub or reset it to factory defaults. |
|
Read or configure the request timeout. |
|
Export settings to a .json file or restore settings from one. |
|
Inspect task results; check module help for parameters. |
|
Read component versions or update firmware. |
|
Read or set system time. |
|
Read or configure the time server. |
|
Save logs to a file or clear them. |
|
Read or set the log level. |
|
Read or configure the syslog destination. |
Back up the Hub before applying bulk configuration changes, restoring settings or resetting it.