Skip to content
English
  • There are no suggestions because the search field is empty.

Manage an ezeep Hub with PowerShell

Use the TPHubPS module to configure a Hub from Windows PowerShell. For a single change, the Hub console is also available.

[Step] 1. Download TPHubPS.dll from the Hub and import it in Windows PowerShell

  1. Open the Hub console’s login page from a Windows computer on the local network.
  2. Download TPHubPS.dll from that page.
  3. Open the downloaded file’s Properties, select Unblock if shown, and confirm.
  4. Open Windows PowerShell as an administrator and change to the folder containing TPHubPS.dll.

Import the module:

Import-Module .\TPHubPS.dll

[/Step]

[Step] 2. Set the Hub URL and authenticate with its administrator password

Set the target URL, replacing the example address with your Hub’s address:

Set-TPHubUri -Uri https://192.168.1.50

The documented setup uses the following certificate option. It accepts the Hub certificate without validation; use it only after confirming that the address belongs to your Hub.

Set-TPHubServerCertificateValidation -Option AcceptAlways

Authenticate with the Hub administrator password, replacing the placeholder:

Get-TPHubAuthentication -PlainPassword "YOUR-HUB-PASSWORD"

[/Step]

[Step] 3. Use Get-Command and Get-Help to find Hub commands and parameters

List the commands supplied by your installed module:

Get-Command -Module TPHubPS

For syntax and available help for a command:

Get-Help Get-TPHubPrinter -Full
Get-Command Get-TPHubPrinter -Syntax

Read the printer list and version information:

Get-TPHubPrinter
Get-TPHubVersions

Use the Hub PowerShell command reference to find the command for a task. Check its parameters before making changes.

[/Step]

[Step] 4. Check firmware support, then authenticate remotely using the Hub’s MAC

Remote PowerShell requires a firmware version that supports it. The initial firmware 2.2.111 release lists remote configuration as unavailable; check the release information for your installed version before using this route.

Download the module package linked from the support guide: TPHubPS in PowerShell Gallery. Extract it on your Windows computer and open PowerShell in the folder containing TPHubPS.dll.

Replace the placeholders with your Hub’s MAC address and administrator password:

Import-Module .\TPHubPS.dll
Set-TPHubServerCertificateValidation -Option AcceptAlways
Add-TPHubClaimEzpHub -Serial "YOUR-HUB-MAC"
Get-TPHubAuthentication -PlainPassword "YOUR-HUB-PASSWORD" `
    -ConnectorSerial "YOUR-HUB-MAC"

The same Hub commands can then be used through the remote connection where supported.

[/Step]

Finish the session

Clear-TPHubAuthentication