Restart a Hub or reset its settings
A restart reloads the Hub without intentionally resetting its configuration. A settings reset returns the configuration to factory defaults while keeping the installed firmware and frontend versions.
On this page
[Step] 1. Download needed logs, then select Reboot and confirm
- Download any logs you need; a reboot clears locally stored logs.
- In the Hub console, open System > Reboot and Reset.
- Select Reboot and confirm.
- Wait for the Hub to return, then reconnect. Use Hub Finder if its DHCP address changed.
If the console is unavailable, disconnect power and reconnect it after a few seconds. Allow several minutes for startup.
[/Step]
[Step] 2. Back up the Hub, select Factory Reset and confirm the settings reset
A factory settings reset removes the Hub’s configuration. Back up your settings first if you need them.
- Open System > Reboot and Reset.
- Select Factory Reset.
- Confirm with Reset.
- Find the Hub again and set it up, or restore a backup.
[/Step]
[Step] 3. Start the Hub with a FAT32 USB stick containing only .factory_reset
Use this method to return network settings to their defaults when the console and PowerShell are unavailable.
- Download the configuration-reset ZIP and extract it.
- Prepare a FAT32-formatted USB stick containing only the extracted .factory_reset file. Formatting erases the USB stick.
- Keep the filename exactly .factory_reset and leave its configuration-reset contents unchanged.
- Disconnect the Hub’s power, insert the USB stick and reconnect power.
- After approximately ten seconds, the red LED stays lit and the green LED flashes rapidly for about ten seconds.
- Remove the USB stick after this sequence.
- Use Hub Finder to locate the Hub and reopen its console. Reconfigure it or restore your backup.
[/Step]
Firmware recovery
If the Hub needs firmware recovery rather than a settings reset, contact ezeep support through the website chat for the procedure appropriate to your device.
After recovery, check the installed version and update to the latest compatible firmware if necessary.